During and on the Ladder Support Software, the communications with the Display may be temporarily interrupted. The following ladder support software is required. SIMATIC S7-1200 Series does not support the Pass-Through Function. STEP7 - Micro/WIN Version 4.0.1.10 or higher

SIEMENS SIMATIC SoftwareSTEP7 Version 5.1 or higher The following programming tools are required. Windows 7 (64 bit) is supported only when RSLogix5000 is used. The following programming support tools are required. The following CPU unit does not support the Pass-Through Function. To use Pass-Through Function, needs to be specified for in the ladder software. If High Performance Unit is written by the Pass Through Function, response of Link Unit temporarily stops and an error may be displayed on the Display. The following programming support tool is required. Windows 7 (64 bit) and Windows 8 (64 bit) are not supported. Pass-Through Function can be used only when the display is connected to the programming port on the CPU. The following programming tool is required. If a communication error occurs in the engineering tool while using the pass-through function, increase the amount of time in the driver's field. When GP-3200 series, GP-3300 series, and LT3000 series are connected with the MP3000 series, the ladder program cannot be read out with the pass-through function. The following engineering tool is required. When using a hub, GX Works3 may generate the following error, 'Unable to communicate with PLC.' Additionally, set the GP-Pro EX to 60 seconds or more. Set up 120 secords or more for GX Works3's.

However, you can connect 1 device each from iQ-R and iQ-F series at the same time. You cannot connect External Devices from the same series (iQ-R or iQ-F) at the same time. Pass-Through Function can be used only when the display is connected to the Ethernet Port on CPU unit. When using iQ-R/F Ethernet(SLMP Client), the following limitations apply. GX Developer Ver8.114U or higher / GX Works 2 V1.492N / GX Works 3 GX Developer Ver8.98C or higher / GX Works 2 V1.56J / GX Works 3 The following GPP function software packages are required. įor details about how to connect to the Display, click the hyperlink in the Driver column to open the manual PDF (portable document format) file for that driver. When using the Pass-Through Function by SIMATIC S7 MPI Direct Driver, please refer to. Please refer to for installation or settings of the pass-through function. Please see below for required drivers and the system requirements to use the pass-through function.

Gx works2 network parameters